Polyurethane Wood Glue 250gr Pu MAX - Bison

Polyurethane Wood Glue 250gr Pu MAX - Bison

White Craft Glues
GLU280
Part.No: 6305825
€9.95
In Stock
Immediate Dispatch

Liquid, waterproof (EN 204 D4) wood construction adhesive based on polyurethane

 

PROPERTIES

  • Liquid
  • (Sea)waterproof (EN 204 D4)
  • Super-strong
  • Limited filling; slightly effervescing
  • Solvent-free
  • Temperature and all-weather resistant
  • Can be used internally and externally
  • Paintable
  • Sandable

SUITABLE FOR:

For water-resistant (EN 204 D4) mutual (surface) joining of practically all types of wood as well as joing practically all types of wood to many building materials, such as gypsum, (natural) stone, (cellular) concrete, metal, hard foam and various synthetics. Especially for bonding and repairing wood constructions and wood connections that have to meet stringent requirements. Suitable for finger joints, dovetail joints, mortise and tenon joints, dowels, springs, and more. Suitable for interior and exterior applications, such as façade carpentry and sandwich panels. Also for less-fitting joints (for example, unplaned wood). D4: Interiors where flowing water or condensation are present over long periods on a regular basis. Exteriors exposed to the influences of the weather, providing effective protection for bonded wood.

NOT SUITABLE FOR:

Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and nylon (PA).

BEFORE USE:

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5 °C. Relative humidity of up to 65 %. Level of wood humidity between 10 % and 18 % (max. 25 %).

Surface requirements

The surfaces to be bonded need to be clean, dry and free of dust. Moisten the side to which no adhesive has been applied with a damp cloth.

Preliminary surface treatment

Degrease oily types of wood with thinner. Roughen non-porous materials.

Tools

Fine-toothed glue spreader (1 mm), brush or roller, clamp or press.

Coverage

5-6 m²/kg

DURING USE:

Directions for use

Apply adhesive thinly and evenly to one side using a fine-toothed glue spreader (1 mm) or brush. Assemble joint within 30 minutes and clamp or press for at least 4 hours. The desired pressure is 2-5 kg/cm².

AFTER USE:

Stains/residue

Remove adhesive residue immediately with acetone. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +10 °C and +20 °C.

11 other products in the same category:
Product added to wishlist
Product added to compare.